Baby BMW Forum banner
1 - 20 of 21 Posts

· Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Just a quick post on here,

Wondering if anyone can point me in the right direction please. I bought a Bmw 116 1.6 and since about 3 month ago the engine light came on. So I got it checked out and read, and it's showing low efficiency below threshold bank one. But the car has started jumping into limp mode and not responding to the accelerator. So I've cleaned and replaced the throttle body and removed the light but after around 70 mile the same code came back.

has anyone got any ideas.

Thanks jamie
http://
That's when it jumped into limp mode and couldn't do anything with it

uploads.tapatalk-cdn.com/20160131/0724af6c2205a80848690cabd401d94d.jpg

Thanks a lot jamie

Sent from my iPhone using Tapatalk
 

· Registered
Joined
·
1,952 Posts
Oxy/Lambda sensor ?
 

· Registered
E82 135i/1m ,2018 240i
Joined
·
13,542 Posts
Cat isn't working

It monitors front and rear oxygen sensors caclucates if the cat is working

Sent from my SM-N910F using Tapatalk
 

· Registered
E82 135i/1m ,2018 240i
Joined
·
13,542 Posts
Without seeing your exhaust system I can't say, but it can only measure the cat that the oxygen sensors are in front of and hehind of

But at guess it would be the front cat

Sent from my SM-N910F using Tapatalk
 

· Registered
E82 135i/1m ,2018 240i
Joined
·
13,542 Posts
Jamieward95 said:
Should I try and replace the bank 2 sensor ?

Sent from my iPhone using Tapatalk
You mean bank 1 sensor 2?

You can try it, it's very much a gamble until you find the fault but in my experience that code normally means cat fault

Sent from my SM-N910F using Tapatalk
 

· Registered
E82 135i/1m ,2018 240i
Joined
·
13,542 Posts
Blackbmw120d said:
rob180bhp said:
Blackbmw120d said:
If anyone would like one if the above fault scanners, guess what :) Pm me with an offer.
Show us the scanner

Sent from my SM-N910F using Tapatalk
Same as the one in the thread :thumbs:
Got a name or number for it so I can't gauge a price

Sent from my SM-N910F using Tapatalk
 
1 - 20 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top