Baby BMW Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
170 Posts
Discussion Starter · #1 ·
Hi there I am looking at possibly remapping my 130i. Please can I ask some questions?

Your website suggests 15 bhp and 10ft/lb torque. I assume these are peak gains, can I ask what the low and mid rpm gains are like, maybe an example dyno if you have one?

Also is this on 95 Ron fuel?

I assume there have been no issues since this setup has been created, and that nothing is near any reliability limits?

Lastly do you know the standard rev limit and if it is worth making this slightly higher unless this is a risk of course?

Thank you.
 

·
Vendor
Joined
·
47 Posts
Leejay-B said:
Hi there I am looking at possibly remapping my 130i. Please can I ask some questions?

Your website suggests 15 bhp and 10ft/lb torque. I assume these are peak gains, can I ask what the low and mid rpm gains are like, maybe an example dyno if you have one?

Also is this on 95 Ron fuel?

I assume there have been no issues since this setup has been created, and that nothing is near any reliability limits?

Lastly do you know the standard rev limit and if it is worth making this slightly higher unless this is a risk of course?

Thank you.
Hi

You can read a review and see a dyno graph here.


This is on 98 RON fuel. I would expect slightly less gain on 95 RON.

As with most NA cars gains are going to be more noticeable at the top end.

We have had no reported issues with our map on this car since we started doing them in 2007.

No advantage in raising the rev limiter.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top